Established in 1979, Odyssey of Wharton NJ manufactures first response EMS units, Chief and Command units, Specialty law enforcement, Security and commercial vehicles based on sport utility vehicles, vans, trucks, buses and light rescues.

  • By using the following program you can "Spec-Out" an Emergency Response Unit and submit it to Odyssey for a proposal and information.
  • The following is our Stepvan, Truck and Trailer conversion package. If you do not see it mention it in the notes section.
  • Chassis may be supplied by the customer, ordered and drop shipped to Odyssey or supplied through the Odyssey chassis network. Contact our sales department for pricing or our factory drop ship codes.
CONTACT INFORMATION (*) signify required fields.
Name:*
Title / Position:*
Company Name:*
Email Address:*
Phone Number:*
Fax Number:*
Street:*
City or Town:*
State:*
Zip Code:*
How did you hear of us?*
Budget Amount:*
Will you be going to bid? Yes No
If so, do you need bid specifications? Yes No
What is your time-frame?*
Preferred contact?*
SPEC YOUR CONVERSION
VEHICLE INFO:
MAKE PREFERRED : ENGINE :
TYPE : CHASSIS SUPPLIED BY:
ELECTRICAL
POWER PACKAGE: High power 170 amp alternator (image)
  Emergency Vehicle battery system
  Odyssey automatic electronic engine idler unit.
IGNITION OVERIDE Remove key from ignition securely.  
BACK UP ALARM Automatic sound level Adjusting.
POWER POINTS 12-Volt DC power outlets included on rear corners & front control console.
120 VOLT ELECTRICAL
GENERATOR (Permanent) Installed in an above floor air tight compartment with interior cover & exterior access door. Remote panel on the interior.  
   
  Trailer application? Add fuel cell, gauge & Tray  
GENERATOR (Portable) Installed on a pull out tray in an exterior compartment or on tongue of trailer in tray with lock.  
   
INVERTER Wired to battery system and transfer switch system  
 
*Tips on selecting an inverter. Important 		 
BATTERY CHARGER/ MONITOR Shore power charger to battery system  
  Roof mounted solar charger to charge batteries  
SHORE POWER INLET Shore inlet with circuit protection and adapter
UNDERHOOD LINE Underhood line for engine block heaters.
DISTRIBUTION PANEL Custom panel with switches and circuit breakers  
TRANSFER SWITCH Automatic Transfer switch from shoreline to generator or inverter  
EXTERIOR OUTLETS Weatherproof GFI protected outlets on exterior of body  
 
INTERIOR OUTLETS Duplex GFI outlets on interior of body  
 
UNDER HOOD LINE Circuit protected line to existing engine block heater.  
BLOCK HEATER Add factory STD block heater.  
EXTERIOR
BODY ENTRY DOORS Rear entry door with screen  
Side entry door with screen  
Manual pull out step for side door  
Electric pull out step for side door  
RAMP Swing out spring loaded aluminum ramp for heavy duty equipment  
EXTERIOR COMPARTMENTS With door and locking handle  
In body with swing open door. Qty:
In body with roll up door. Qty:
Underbody box with swing open door. Qty:
WINDOWS Tinted safety glass windows  
   
CURTAINS

Full wrap around windshield curtain
Window curtains, small
Window curtains, large
AWNING One pullout awning with support legs
ASSIST HANDLES Assist handles at each door opening
REAR STEP Fold down rear step secured to the rear bumper including hold back supports when not in use.
ROOF DECK Custom Aluminum nonskid roof deck with removable aluminum rails.
LADDER
TRAILER HITCH Heavy duty class 4 receiver hitch & wiring
LETTERING & GRAPHICS Scotchlite and computer generated exterior graphics. Pricing is available after a design is submitted.

INTERIOR
CONSOLE Stepvan - Desk area to the right of the driver
Cab & Chassis - see std price list
Van motor cover console - small console mounted to motor cover
MAIN BODY AREA - Interior finish
WALLS Insulated and covered with Light gray marine carpet.

Insulated and covered with Smooth white FRP
Other:
CEILING Insulated and covered with Light gray marine carpet.
 

Insulated and covered with Smooth white FRP

  
  Other:  
FLOOR Lonseal ambulance style covering
Commercial carpet to existing floor
Polished aluminum diamond plate
Painted with non-slip coating
PARTITIONS Separating compartments  
   
     
CABINETRY
OVERVIEW Odyssey cabinetry is manufactured from the finest and most durable materials available. The main structure is framed from special MDO plywood and covered with high pressure counter grade laminate or marine grade carpet materials. For added durability the edges are trimmed with PVC bumper strip installed into a machine slotted edge, drawer faces and doors are composed of unbreakable HDP composite and Odyssey uses only the highest quality hardware in the industry.
COUNTER Counter / Desktop laminated with PVC bumper strip edge  
4' - 6' Length 8" - 12' Length  
     
FILE & PARTS DRAWER One file and one storage drawer under the counter  
   
LOWER CABINETS Lower cabinets up to 48", enclosed with one adjustable shelf and a latching door up to 36" tall and 16 to 24 inches deep.  
16" to 24" wide 24" to 36" wide
  Additional shelves?  
TALL CABINETS Enclosed cabinets up to 84" with 3 adjustable shelves  
Aluminum Shutter door Swing open latching door  
  16-24" wide 24-36" wide  
OVERHEAD CABINET Cabinet above the counter with lift-up doors and piston hold opens  
4' - 6' wide 8' - 12' wide  
Radio panel with removable face?  
SINGLE SEATING Office Chair with tie downs  
FMVSS Captain's chair w/ integral seat belt removable?  
BENCH SEATING With black cushion and lift up base cushion for storage and seat belts  
   
GRAB RAIL Aluminum non slip rail mounted to ceiling  
 
SECURE STORAGE Add locking latch to compartments and drawers  
Add key lock to compartments and drawers  
Add push button combination lock to compartments or drawers  
EQUIPMENT STORAGE SOLUTIONS
"E" TRACK Truck body track high & low on wall
"L" TRACK Wheel chair style track on the floor
SHELVING Full height steel shelving unit secured to wall
FOLDING SHELVES High mounted fold up aluminum shelves
QUICK RELEASE NETS Drop down nets on any storage system
AIR/ OXY CYLINDER MOUNTING Wall mount: two mounts with quick release straps
Enclosure with latching door & drop down clear panel up to 24" wide
Marine hatch with quick connect piped to one tank.
DRY ERASE BOARDS Standard w/ aluminum frame. 24"x36". Qty:
  Magnetic w/ aluminum frame. 24"x36". Qty:  
INTERIOR LIGHTING Dual lamp, 30 watt surface mount florescent lighting throughout interior  
     
HEAT, AC AND VENTILATION
USING SHORELINE 120 VAC Roof mounted 13,5000 BTU AC with heat strip
  Ducted throughout interior  
  Heat: Electric baseboard with thermostat  
WITH ENGINE RUNNING Engine fluid heater in rear of vehicle  
Rear AC & Heat (Must have factory AC in front)  
Engine and 120v combo unit  
BATTERY POWERED 12 VDC Roof Vent - manual non powered  
Powered roof vent - 3 speed reversible with thermostat  
Hidden system: 12 VDC blower through ambulance vents  
WARNING SYSTEMS
LIGHT BAR(S) Please specify light bar and include worksheet.
 
WARNING LIGHTS LED LIGHTING
Front - on grille (total two)
Side Low - on front fenders and over rear wheels (total four)
Side High - on top of body (total four)
  Rear Low - Above Tail lights (total two)  
  Rear High - Top of Body (total two)  
SCENE LIGHTING 12 volt Halogen
Front - front edge of body (total two)
Side High - Top of body (total four)
Rear Low - Above tail lights (total two)
Rear High - Top of body (total two)
Light Tower - Extendable light tower with two 70 watt metal halide heads.
SCENE LIGHTING 120 VOLT AC HALOGEN
Front - on telescoping poles, 500 watt (total two)
Side High - Recessed into body, 500 watt (total two)

Rear High - On telescoping poles, 500 watt (total two)
Rear Low - Recessed into body, 500 watt (total two)
Light Tower - Two 500 watt heads.
  Light Tower - Four 500 watt heads.  
SIREN AND WARNING 100 watt Whelen siren to 1 speaker
200 watt Whelen siren to 2 speakers
AIR HORNS Dual air horns mounted in front bumper with compressor & tank  
PERSONAL LIGHTING Streamlight SL40 Lightbox with charging rack.
Streamlight SL20 flashlight.
COMMUNICATIONS EQUIPMENT
COMMUNICATION EQUIPMENT Radio and antenna installation is available and can be quoted after a detailed list of equipment is submitted
VIDEO Drop down 10" - 15" flat screen display
Wall mount 15" flat screen display
Backup camera with audio
  Roof mounted camera  
  VHS recording device  
  DVD-R recording device  
ADDITIONAL COMMENTS HERE
Thanks for your input, please click submit to access Odyssey's Spec Online section.
(resets to default package)

ODYSSEY TERMS

Conversions: 35% down at the time of the order with the balance with all additions to be paid in full upon completion and acceptance of the unit.

Chassis: The chassis must be paid in full when it arrives at Odyssey. If two payments are more convenient then the chassis can be paid in full along with the conversion deposit. Any delay in payment will accrue a charge of
$10.00 per day interest until the chassis is paid in full.
Chassis must be paid in full when the chassis arrives at Odyssey.

Pricing: is subject to change but all quotations will be valid for 60 days. Chassis, quotations are subject to availability and is only valid at the date of the proposal. All quotations exclude any applicable sales or use taxes unless specified and included with the price. FOB-NJ

Applicable Law: The terms and provisions of this Contract and any dispute arising hereunder shall be governed and principles of law applied by the laws of the State of New Jersey. The courts of New Jersey shall have the sole and exclusive jurisdiction in any case or controversy arising under this Contract. Each party to this Contract, inclusive of its successors or assigns hereby submits and consents to the jurisdiction of the courts of the State of New Jersey and within which all such actions, unless otherwise provided for the arbitration of said disputes, shall be the proper venue for any such action.

Communications equipment: All customer supplied communications equipment must be complete, fully operational and programmed upon arrival at Odyssey. Equipment not complete will be installed in the designated locations with all wiring in place but not attached to the equipment. Odyssey's responsibility will end at that point and it will be necessary for your communications vendor to complete the installation. Odyssey shall not be responsible for any customer supplied equipment not 100% functional upon arrival. If you request the supplied equipment be serviced Odyssey will make the arrangements at a qualified local vendor. The department shall be responsible for any and all charges incurred. This service will postpone the start of production time quotations until the equipment is returned in working order. There are no warranties implied by offering this service.

Warranty: The chassis is warranted by the manufacturer of the chassis. Odyssey has a full limited warranty supplement that will be included with the owners manual upon delivery. If you would like a copy prior to contract please ask for a copy.

Production time: is 4 to 6 weeks depending on type of conversion and chassis details after arrival of the chassis at Odyssey and all plans are approved. If a contract and all approvals are submitted prior to the arrival of the chassis the production time will be considerably less. At any time during construction, consider yourselves our guests to stop by and view or discuss your conversion.

© 2008 Odyssey Automotive | All Rights Reserved | Questions? Comments? Contact Webmaster