OPTIONS	ESU UNIT and Utility SWAT-OPTIONAL EQUIPMENT that can be added if not included in the package above.
Emergency Start System	Emergency start jumper cable system with a high quality molded plug including 2 gauge wire mounted on the front grille guard clear of the front of the bar. Included shall be an illuminated, labeled switch on the dash activated by ignition operating a solenoid. Wiring includes a service loop at plug receptacle and include one set of 16' 2/0 cable including one female plug on one end and 800 amp alligator clips on the other. Label to be LED rear illuminated: Emergency Start System
Shoreline 30A twistlock	Shoreline: 30 amp twist-lock marine receptacle mounted on the left rear side of the vehicle wired to a junction box with circuit breaker protection and two multi outlet strips for equipment.
Shoreline indicator light - int	Shoreline: Power on indicator mounted on the console or dash activated when power is applied to the shore line.
Inverter: 1000w mod sine & install	Modified wave: 1000 watt inverter installed in the rear of the vehicle wired to one outlet strip and an on/off switch on the console or rear radio area.
Inverter: 2000w mod sine & install	Modified wave: 2000 watt inverter installed in the rear of the vehicle wired to one outlet strip and an on/off switch on the console or rear radio area.
Inverter: 1000w pure sine & install	1000 watt Pure Sine Wave inverter installed in the rear of the vehicle wired to one outlet strip and an on/off switch on the console or rear radio area.
Inverter: 2000w pure sine & install	2000 watt Pure Sine Wave inverter installed in the rear of the vehicle wired to one outlet strip and an on/off switch on the console or rear radio area.
30A transfer switch	Automatic transfer switch located in the rear of the vehicle and wired to automatically transfer power from an on board inverter or a generator to the shore line when power is applied to the shore line.
Underhood Line	Circuit protected line terminating underhood for an existing engine block heater
Graphics Std Van	All reflective material is 3M Scotchlite 680 and high quality custom vinyl material. Included is a Scotchlite stripe and up to 60 single color Scotchlite letters. A detailed color drawing will be submitted for approval after the order is placed.
Bumper winch upgrade	Add 12,000 lb winch to front HD push bumper
Will-Burt NS-6-300DC	Nightscan Chief light tower, 12 volt with dual 150 watt lightheads mounted on roof with pistol grip controller. This tower will raise, lower, pan, tilt and telescope approx 72" off the roof. Included is an aluminum treadplate branch guard housing surrounding the tower.
Rear Lightbar	Whelen mini Freedom lightbar with 4 corner LED on the roof of the body.
Scene light pkg #2	Two pole mounted 500 watt halogen scene lights, 120 volt. Mounted and wired to breaker panel. Sold in pairs.
Scene light pkg #3	Two removable tripod 500 watt halogen scene lights, 120 volt. Mounted and wired to breaker panel. Sold in pairs.
Rear Camera System	Rear view color backup camera
Radio install - Single	Customer supplied, install a single unit radio in the console and wire to an antenna on the roof.
Radio install - dual	Customer supplied, install dual head radio with one head installed in the console and the second head in the rear command area, wired to an antenna on the roof.
Portable charger install	Customer supplied portable radio charger in the console pocket and wire to constant power.
Scanner BC350 & install	Supply and install a Uniden BC350 scanner in the console.
GPS unit	Supply and install a Magellan, Gramin or TomTom GPS system with voice and countrywide software mounted by the console near the dash.